Renogy 2000W 12V Pure Sine Wave Inverter
The Renogy 2000W 12V Pure Sine Wave Inverter converts power from a 12V battery bank into household AC power for vans, RVs, cabins, boats and camping setups. It delivers 2000W continuous with a 4000W surge, has three AC sockets, a hardwire AC terminal block and a 5V/2.1A USB port, and weighs 11.7 lbs. It is a DC-to-AC inverter only and does not charge batteries.
2000W Continuous Output With a 4000W Surge
The Renogy 2000W 12V Pure Sine Wave Inverter provides 2000W of continuous output (16.6A AC) and a 4000W surge rating for 1 second, intended for devices with a high start-up load. Output frequency is 60Hz. Conversion efficiency is above 90%, and above 85% at full load.
Pure Sine Wave Power for Sensitive Electronics
The pure sine wave output has total harmonic distortion below 3% on linear loads and below 5% on non-linear loads. Renogy states that inductive loads such as microwave ovens and motors run faster, quieter and cooler on a pure sine wave inverter, and that it reduces noise in fans, lights, audio equipment and TVs.
Three AC Sockets, a Hardwire Terminal Block and USB
Plug devices straight into the three AC sockets, or use the high-output AC terminal block to feed a load sub-panel or additional outlets, or devices drawing more than 15A. A built-in 5V/2.1A USB port charges phones and tablets. Installation should be done by a qualified person following local electrical codes.
Wired Remote Control With 16.4 ft Reach
An ON/OFF/REM switch on the inverter lets you turn it on and off at the unit or from the included wired remote control. The remote connects through the included 5 m (16.4 ft) RJ11 network cable. Status LEDs show power, GFCI and fault conditions.
Built-In GFCI and Multiple Protections
The Renogy 2000W 12V Pure Sine Wave Inverter has an integrated ground fault circuit interrupter (GFCI) plus overload, overtemperature, overvoltage, short-circuit and undervoltage protection. Thermally controlled cooling fans manage heat, and the unit is ETL listed to UL 458 and CSA C22.2 No. 107.1-01.
12V Battery Systems Only
This inverter works only with 12V battery banks, not 24V. Renogy lists deep-cycle sealed lead-acid, flooded, gel and 12V lithium batteries as usable. Leave at least 10 in of clearance around the inverter for ventilation, and keep it out of the battery compartment.
Key Features
- 2000W continuous output, 4000W surge (1 second)
- Pure sine wave output, THD below 3% (linear load)
- Conversion efficiency above 90%, above 85% at full load
- 3 AC sockets plus 1 high-output AC terminal block
- 5V/2.1A USB power port
- 12V DC input only (M8 terminals)
- Wired remote control with ON/OFF/REM switch, 16.4 ft cable
- Integrated GFCI, overload, overtemperature, overvoltage, short-circuit and undervoltage protection
- Thermally controlled cooling fans
- Includes two 1/0 AWG 3 ft inverter cables
- ETL listed to UL 458 and CSA C22.2 No. 107.1-01
- Operating temperature -4°F to 104°F (-20°C to 40°C)
- 11.7 lbs, 17.8 x 8.6 x 4 in
Specifications – Renogy 2000W 12V Pure Sine Wave Inverter
| Specification |
Details |
| Brand |
Renogy |
| Model |
RNG-INVT-2000-12V-P2 |
| Product Type |
12V Pure Sine Wave Inverter (DC to AC, non-charging) |
| Continuous Output Power |
2000W |
| Continuous Output Current |
16.6A AC |
| Surge Rating |
4000W (1 second) |
| Output Waveform |
Pure sine wave |
| Output Voltage |
115V AC |
| Output Frequency |
60Hz |
| Total Harmonic Distortion |
Below 3% (linear load), below 5% (non-linear load) |
| Power Factor |
0.9 to 1 |
| Efficiency |
Above 90% (above 85% at full load) |
| AC Outlets |
3 AC sockets + 1 AC terminal block |
| USB Power Port |
5V/2.1A |
| Power Output Control |
AC ON/OFF/REM switch and wired remote control |
| Rated Battery Input Voltage |
12V DC |
| Maximum Continuous Battery Current |
166.6A |
| DC Terminals |
M8 - 1.25 x 15 mm |
| Cooling |
Thermally controlled fans |
| Certifications |
ETL listed to UL 458 and CSA C22.2 No. 107.1-01 |
| Dimensions |
17.8 x 8.6 x 4 in (452 x 218 x 102 mm) |
| Weight |
11.7 lbs |
| Operating Temperature |
-4°F to 104°F (-20°C to 40°C) |
| Storage Temperature |
-40°F to 158°F (-40°C to 70°C) |
| Wired Remote Cable Length |
16.4 ft (5 m) |
What's in the Box
1 x Renogy 2000W 12V Pure Sine Wave Inverter
2 x 1/0 AWG 3 ft Inverter Cables
1 x Wired Remote Control
1 x RJ11 Network Cable (5 m)
1 x User Manual